Bad cabling, weak Wi-Fi, and undersized infrastructure cost more to fix after buildout than to spec correctly before it. Layer8 designs and installs the physical layer for SMBs — structured cabling, wireless, AV, surveillance, fiber, and access control — so your IT team or MSP inherits something that works.
Most technology problems that look like software or configuration problems are actually physical layer problems — insufficient bandwidth, dead zones, improperly terminated runs, or security cameras that weren't positioned for evidentiary value. Layer8 infrastructure engagements start with a site assessment so we understand the environment before we spec anything.
A Cat5e run where Cat6A was needed. Access points positioned for coverage rather than capacity. A camera system installed for deterrence rather than identification. These decisions look cheap at install time and expensive for the next five years.
Layer8 infrastructure work is designed to hand off cleanly — to your MSP, your IT team, or our own advisory practice. Every engagement produces as-built documentation so whoever comes next isn't starting blind.
Most infrastructure projects touch more than one of these. We scope them together so the work integrates — cabling supports the AV design, wireless capacity accounts for access control devices, fiber runs serve both data and surveillance.
Cat6A horizontal runs, patch panel termination, rack build-out, and cable management — designed to TIA-568 standards and documented with as-builts. The backbone every other system depends on.
Predictive and post-installation RF surveys, access point placement for capacity not just coverage, SSID architecture, VLAN segmentation, and guest network isolation.
Conference room AV, display mounting, video conferencing integration (Teams Rooms, Zoom Rooms), digital signage, and PA systems — designed for the room, not the spec sheet.
IP camera systems positioned for identification, not just deterrence. NVR/DVR architecture, remote monitoring, retention policy design, and documentation for insurance and compliance requirements.
Single-mode and multimode fiber design, fusion splicing, OTDR testing, and documentation — for inter-building runs, high-density server environments, and backbone upgrades that copper can't support.
Card reader and keypad access control, door hardware integration, visitor management, time-zone scheduling, and audit trail configuration — tied to your identity system where possible.
Every infrastructure engagement follows the same sequence — because skipping the assessment or skipping the documentation is how you end up with a system nobody understands six months later.
We walk the space, document existing infrastructure, identify constraints (conduit paths, ceiling access, power locations), and scope what's needed. No spec before the walk.
Floor plan markup, bill of materials, labor estimate, and timeline — reviewed with you before anything is ordered. We explain the design decisions so you understand what you're approving.
Clean installation to spec, coordinated with your general contractor or facilities team where the buildout is active. We handle scheduling around your operations.
Every run tested and certified. Wi-Fi validated with post-installation survey. Camera coverage verified against the design. Nothing signed off until it passes.
Labeled floor plan, port schedule, cable schedule, equipment inventory, and configuration notes — delivered at project close so your IT team or MSP isn't guessing.
We hand off to your team, your MSP, or our own advisory practice. No lock-in, no ongoing dependency on us for day-to-day operations. You own the infrastructure and the documentation.
A 30-minute call scopes what's needed and whether a site walk makes sense. We work in the metro Atlanta area and select projects nationally.
[email protected] · Marietta, Georgia